Robbans Speed Shop AB
Search our website
Products
Searching...

Shoppingcart

{{articleCount}} 0 {{articleString}} Articles
Previous Product
IDIOT LIGHT RELAY & COVER FOR 45CI AND EARLY BIG TWIN

IDIOT LIGHT RELAY & COVER FOR 45CI AND EARLY BIG TWIN

ELECTRONIC VOLTAGE REGULATOR & IDIOT LIGHT RELAY COMBO

Next Product
ACCEL'S DELCO TYPE MECHANICAL VOLTAGE REGULATOR

ACCEL'S DELCO TYPE MECHANICAL VOLTAGE REGULATOR

The mechanical type relay as found on all 1938 thru 1954 45CI and Big Twin has a number of disadvantages. It was proven unreliable and there was no way the output voltage was regulated, so not very easy on the battery. This solid state full electronic item is very reliable and controls the voltage to your battery. Also available in a version for models that have been converted to a 12 Volt system. It fits under the stock relay cover, which we also have available in your choice of black and chrome.


Specifications

Article number Description Retail price Add to cart
745954
Electronic regulator. Replaces the OEM 74750-38 relay on 6 volt models that have been upgraded with a 2-brush generator 2 211,03 kr
745955
Electronic regulator. For models converted to 12 Volt using a 2-brush generator 2 211,03 kr
745956
Relay cover, chrome (OEM 74755-38) 331,63 kr
745957
Relay cover, black (OEM 74755-38) 331,63 kr

Recommended Retail Prices include 25.00% sales tax.

Prices exclude shipping, import duties and installation.

Prices are based on EUR to SEK interbank rates obtained daily. The interbank rate is the rate that banks trade currency to each other. These prices must be used as a guide.

Polarizing generators and regulators
The following information and instructions are for your use, so your warranty will by in effect. No warranty can be in effect if these instructions are not followed. Whenever any component of a generator charged electrical system is serviced it is necessary to re-polarize the complete system, making sure it has the correct polarity so the system will charge in the right direction. If the system is put into service with the wrong polarity it may result in burned relay points, a dead battery and damage to both the regulator and generator.
Instructions:
1. To polarize a generator system with a mechanical regulator, momentarily connect a jumper wire of adequate gauge (a battery cable is ideal) between the “bat” and the “gen” terminal on the regulator after all wires have been properly connected and before starting the motor.
2. To polarize a generator system with electronic regulator/ rectifier. Before mounting the generator of the vehicle, place the generator on a non conducting work surface (like a wooden bench) and connect the positive terminal of a battery to the armature terminal of the generator. Then momentarily “flash” the negative battery terminal to the generator field terminal.